Completion of starboard bottom

June is upon us once again. I have now been working on my Glen-L Utility for just over two years. A good two years it’s been, too. The little boat and I have both come a long way, in many regards.

I’ve just completed planking the full length of the starboard bottom. It’s neat to think that a year ago, I was installing the sheers.


I should be able to start dry-fitting the forward port bottom this week. My goal is to have the boat fully-planked by the end of the month.

As always, time will tell...



This is what the boat looked like 1 year ago. The sheers had just been installed, and fairing had not yet begun.

Initial fitting of the butt blocks.

Butt blocks dry-fit with screws.

Butt blocks epoxied, screwed & clamped into place. Putty knife at the ready.

Epoxy squeeze-out like this will create a fitting nightmare if you let it cure this way.

Thats what the putty knife is for. Scrape it away before it cures.

Aft section battens & butt blocks drilled & ready-to-go.

Aft panel drilled & ready-to-go.

Starboard bottom, fully planked.



Related Posts by Categories

0 comments:

Post a Comment