A kitchen scale saves the day

I took another boatbuilder’s suggestion, and bought a kitchen scale to use in measuring my epoxy mixtures. This simple device I bought for about $30 at K-Mart has made a huge difference. I can now precisely measure any given amount of epoxy, with no guesswork. It’s such an obviously superior method that I wish I’d done it this way all along.

Not surprisingly, the last 2 layers of epoxy went on easily, with no problems whatsoever in curing time. With the stem & related parts now encapsulated, I could move on to finishing the side planking.

On February 15, the 1-year anniversary of my heart surgery, I got the forward starboard planking attached.

Again, the kitchen scale was an indispensable part of the process, and really saved my tail at one point. With weight-based measuring, the Silvertip Gel Magic is mixed at a 1:0.41 ratio, (rather than the 2:1 ratio by volume.) I had mixed a little over 150 mL, because I had a considerable amount of area to cover: both surfaces of the butt joint, the forward 7 feet of chine and sheer, the side of frame #2, the upper part of the stem, and all the same mating surfaces on the planking itself.

I ran into trouble about 3/4 of the way through this batch of epoxy. Enough time had elapsed that the mixture had become so viscous that it was unworkable. At that point, I had coated everything on the boat framing, and had only just coated the mating surface for the butt block on the planking. I had all the rest of the planking left to go.

Luckily, I had 1 extra mixing cup and 1 extra chip brush on hand. Going quickly back to the kitchen scale, I mixed a small batch of approximately 75 mL, allowing me to finish the job. The epoxy cured solidly by the end of the afternoon.

The next day, I faired off the front of the starboard planking at the stem, and started fitting the port side.





Starboard side planking, finally attached!
Now to fit the port side.

Related Posts by Categories

0 comments:

Post a Comment