False battens blocking for deck framing and shiny stuff

Trying to push this project on toward completion, tonight I started measuring for the deck framing. So far, it has been mercifully simple.

I clamped my big adjustable T-Square onto the forward frame at the centerline, and measured the halfway point between the frame and the breasthook. Then, I set my 48" ruler across that halfway point, at right angles to the T-Square. After determining the rulers contact point with the sheer was an equal distance from the frame on both sides, I clamped the ruler into place, and marked the sheers. Then, I measured the angle at the intersection of the ruler and the sheer. Thankfully, it was a very easy-to-cut 20°. 

Measuring for the deck framing.

The blocking for the deck framing required a simple 20° cut. Here is the starboard side being epoxied into place.

Blocking for the deck framing on the port side.

Here, the false battens on the floor are being epoxied into place. All those boards look a little excessive to my eye, but the false battens do serve a practical purpose.

Tonight I drilled the holes & installed the stainless steel grab handle on the forward frame. The first time I rode in a Glen-L Utility, I realized this is a "must-have" item.

Progress...

Related Posts by Categories