Sanding

When we last left off at the previous blog post, it was time for a lot of sanding on the Utilitys hull. That is exactly what I’ve been doing for the last couple of weeks. I’ve done enough sanding, in fact, that I’ve come to a new realization: 

Up to this point in my life, I did not fully grasp the true definition of the word “dust.”

Sanding this boat hull in preparation for fiberglassing it has generated a colossal amount of fine red dust that has covered absolutely everything in my garage. My poor shop vac is trying valiantly to keep up.

In any case, there is still more sanding to be done.

Since it’s now August, I thought I’d post a couple of updated progress photos. All the sanding has revealed a spot on the forward port side where the bottom of a frame did not get adequately faired, resulting in a little “bump” in the plywood. I obviously didnt see this before... perhaps due to the amount of extraneous plywood that was overhanging the side. It’s really best to avoid this type of thing, but there’s not much I can do about it now.

Current state of the hull. Soon it will be time for a little fairing compound.

Frame #2, which is about an inch aft of this bump, apparently had a high spot that I did not catch, resulting in this bump in the planking. Fortunately, it does not feel to the hand as bad as it looks to the eye. Ill fill in these spaces with fairing compound. After fiberglass and paint, I dont believe it will be very noticeable.

This is the shimmed area at the port aft, where I had accidentally gouged the side planking. I think it will look fine once the hull is painted.

Related Posts by Categories

0 comments:

Post a Comment